✅ Sensor functions:

⭐⭐⭐⭐⭐

• Audible alarm, voice message, and visual alarm via LED diode
• Wired power supply and 9V rechargeable/standard battery backup (not included)
• Uses a high-quality semiconductor sensor and advanced electronic technology.
• Real-time detection of combustible gas leaks.
• Response time: under 30 seconds.
• Additionally, the sensor has an output contact for a DC12V or 12V manipulator. The CX70 detector, by sending a signal, serves as a controller that activates an external shut-off valve. This means that after the alarm is triggered, in addition to the audible-optical signal, the detector issues a command (electric pulse) to the manipulator to close the gas flow, thereby increasing safety.

✅ DEVICE INSTALLATION

• Location: The detector and combustible gas appliances should be located in the same room.
• Distance from source: It should be located at a distance of 1 to 3 meters from the potential air source.
• Wall Mounting: Higher than doors and windows, but at least 150 mm from the ceiling.
• Ceiling Mounting: At least 300 mm from any wall.
• Gases lighter than air (natural gas): Installation at a higher level.
• Gases heavier than air (LPG): Installation at a lower level.

Startup warming up

1. Power connection, signaling: Red and yellow LEDs turn off, and the green light stays on continuously.
2. Warming up: The detector enters the warming up state, and the light begins a 180-second countdown.
3. Readiness: After the countdown ends, the lamp displays the OP symbol, and the detector enters the normal monitoring state, with the green LED illuminated.

✅ SENSOR APPLICATION AREAS:

⭐⭐⭐⭐⭐

• Domestic rooms equipped with gas stoves, boiler rooms with natural gas or LPG furnaces, rooms where gas appliances are located, such as: cylinders, meters, tanks, gas pipes.
• Garages for cars with gas installations, school chemistry and physics laboratories.
• The sensor can also be installed in cars and caravans, on boats, and motor yachts.

✅ TECHNICAL DATA

⭐⭐⭐⭐⭐

• Detected gases: combustible gases, natural gas, LPG
• Sensor type: semiconductor sensor
• Alarm threshold: 8% LEL
• Alarm signaling: visual – flashing red LED, acoustic – siren with a sound intensity of approx. 70dB at a distance of 1 m and a voice message.
• Operation signaling: green LED is illuminated.
• Fault signaling: yellow LED flashes and acoustic signaling.
• Power consumption: less than 3W
• Operating mode: continuous.
• Operating temperature: 10°C +50°C.
• Relative humidity: max. 95% RH
• Housing: made of ABS plastic

✅ SET CONTENTS:

⭐⭐⭐⭐⭐

1. Gas sensor,
2. Dedicated mounting bracket,
3. Mounting plugs,
4. User manual in Polish and English!
5. Original packaging.